esp32-bme280
Project Information
Created
Updated
Description
ESP32 creates an open Wi-Fi Access Point (no password) with a captive portal. When you connect, the portal page displays live readings from a BME280 (3.3V) sensor: temperature, humidity, and pressure (auto-refresh every 2 seconds).
Flash to Device
Login required: You need to login or create an account to flash this project.
Source Files (3)
Download AllREADME
ESP32 BME280 Captive Portal (FlashESP)
![]() |
![]() |
Short description
ESP32 creates an open Wi-Fi Access Point (no password) with a captive portal.
When you connect, the portal page displays live readings from a BME280 (3.3V) sensor: temperature, humidity, and pressure (auto-refresh every 2 seconds).
Wiring (ESP32 ↔ BME280, I2C, 3.3V)
Default I2C pins on ESP32 DevKit boards: GPIO21 = SDA, GPIO22 = SCL
| BME280 pin | ESP32 pin | Notes |
|---|---|---|
| VCC / VIN | 3.3V | Sensor power (3.3V only) |
| GND | GND | Ground |
| SDA | GPIO21 | I2C data |
| SCL | GPIO22 | I2C clock |
Notes
- Many BME280 boards use I2C address 0x76 or 0x77. The example code tries both.
- If your module has SDO / ADDR pin, it often selects the I2C address (0x76 vs 0x77).
- Keep wires short for stable I2C (especially on breadboards).
- On ESP32-C3 / C6 / S2 / S3 boards GPIO21/22 may not exist or be mapped differently — use the pins marked SDA/SCL on your board and change
Wire.begin(SDA, SCL)accordingly (e.g.Wire.begin(8, 9)on many ESP32-C3 boards).
Required libraries
Install via Arduino Library Manager:
- Adafruit BME280 Library
- Adafruit Unified Sensor
ESP32 / Arduino core built-ins (no extra install):
- Wire
- WiFi
- WebServer
- DNSServer
How to use
- Flash the firmware to ESP32 using FlashESP.
- Power the ESP32 and BME280 (3.3V).
- Connect to Wi-Fi network: ESP32_BME280 (open network).
- Captive portal should open automatically. If not, open any website or go to
http://192.168.4.1. - The portal page shows Temperature / Humidity / Pressure and refreshes automatically every 2 seconds.

